Projection Screen
To raise or lower a screen, press the corresponding screen Up/Down button on the built-in control panel.
Projection
Turning off the Projector
To turn off the projector, press and hold for five seconds the green Display Power button on the Extron Switcher.
NOTE: The projector will need a few minutes to cool down before it can be turned on again.
Turning on the Projector
Locate the Extron Switcher. Press and hold for 5 seconds the Display Power button to turn on the projector. The Display Power button will illuminate and the projector will take approximately 45 seconds to reach full brightness.
Projection Screen
The projection screen must be pulled down manually.
Projection Screen
There is a fixed wall-mounted projection screen.
Turning off the Projector
On the SONY remote, press the green I/O button twice. This will put the projector in a stand-by mode allowing it to cool down.
NOTE: You will not be able to turn the projector back on during its one minute cool-down period.
Turning on the Projector
On the SONY remote, press the green I/O button and wait 30 seconds.
Projection Screen
To raise or lower the projection screen, press the Screen UP or Screen DOWN buttons on the Extron Switcher, or use the screen's Up and Down controls on the wall next to the equipment rack.
Turning off the Projector
On the Crestron Touch-Screen Panel, select Exit System. Press YES when prompted to continue.
NOTE: The projector will need a few minutes to cool down before it can be turned on again.
Projection Screen
To raise or lower the projection screen, select a source on the Crestron Touch-Screen Panel.